Download OTR Module Instructions for Use

Transcript
Checking the Function
1. Press the POWER switch to turn the unit on. Display used for
root canal preparation will appear.
* The unit will automatically turn off after 10 minutes of
non-use.
* Wait at least 3 seconds after the power goes off before
turning it back on again.
* Do not turn the power on while stepping on the foot switch.
* If there is a sequence of single and double beeps right after
you turn the unit on, the built-in electrode needs to be
replaced. When connecting the motor handpiece to the
handpiece cord and using the module in conjunction with
the root canal measurement function, clean the rotor axle
and replace the electrode before making any measurements.
(see page 43)
After replacing the built-in electrode, press the SET switch
while the alarm is beeping. Then the beeper alarm will be
OFF until next estimated replacement timing.
POWER Switch
2. Check that the handpiece cord is properly plugged into the
jack.
3. Check that the contra angle is securely attached to the
micromotor.
4. Check that the file is properly installed. Give it a light tug to
confirm.
5. Check that the contrary electrode is attached to the connector
of the handpiece cord.
Contrary Electrode
File Holder Contact
6. Contact the file with contrary electrode and check that all the
root canal length indicator bars on the display are lit, the word
“APEX” flashes and audible beep becomes continuous. Use
caution when contacting the file with contrary electrode as the
file starts to rotate as soon as the file touches the contrary
electrode.
• Check the ROOT ZX II’s operation before each patient. If
the indicators in the display do not all appear normally, the
instrument may not be able to make an accurate
measurement. In this case, stop using the instrument and
have it repaired.
17
Operation
2014-07-22