Download MIC-3350

1.9 Jumper and DIP Switch Settings
This section tells how to set the jumpers and dip switches to configure
your card. It gives the card default configuration and your options for
each jumper. After you set the jumpers and install the card, you will
also need to run the BIOS Setup program (discussed in Chapter 4) to
configure the serial port addresses, floppy/hard disk drive types and
system operating parameters. Connections, such as hard disk cables,
appear in Chapter 2.
For the locations of each jumper and switch, see the board layout
diagram depicted earlier in this chapter.
You configure your card to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It
consists of two metal pins and a small metal cap (often protected by a
plastic cover) that slides over the pins to connect them. To "close" a
jumper you connect the pins with the cap. To "open" a jumper you
remove the cap. Sometimes a jumper will have three pins, labeled 1, 2
and 3. In this case you connect either pins 1 and 2 or 2 and 3.
1
Open
Closed
2
3
Closed 2-3
You may find a pair of needle-nose pliers useful for setting the
jumpers.
If you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative
before you make any changes.
Chapter 1 Hardware Configuration
13