Download Fibre Positioner User Guide

AAO
Fibre Positioner
2dF/6dF CONFIGURE User Manual
Page 69 of 69 Issue 1.5, 01 Dec 2006
Figure 30 Hour angle test fails
By running the cursor over the fibres, you can easily pick up fibres 258 and 255, and you can
see that the button on fibre 258 is indeed allocated rather closely to fibre 255. The easiest
thing to do is click on fibre 258 then select the ‘Deallocate fibre’ command from the
commands menu. If you run the test with the ‘attempt to reallocate invalid fibres’ button
checked this has the same effect. 11 Appendix B – Bug reporting
No program is perfect, and you may find bugs in CONFIGURE. If you do, please report them
to Chris Ramage, at AAO ([email protected]). Do, please, include as much detail as
possible. Bear in mind that most aspects of CONFIGURE have been tested and found to work
on the test fields and operations tried on them. If you have hit a bug, you have probably got
something unusual in your input data or in the sequence of operations you attempted. (It may
not seem unusual to you, but if it induces a problem then it probably is something that has not
been attempted during testing at AAO.) Generally any bug that can be reproduced can be
fixed reasonably easily, so the important thing is to include as much detail as is needed to
reproduce the bug. In many cases, this means supplying the input .fld file in question, and a
description of just what sequence of operations caused the problem to show.
___oOo___
Last printed 28/06/2006
Last modified by Tony Farrell 24/10/2007 13:49