Download Microflex Wireless User Guide-English

①
Installation
③
Power the Hardware
① Audio Network Interface (ANI)
Connect the IEC power cable from the back panel to an AC power source. Turn on the power switch.
1
2
3
1
4
2
②
4
3
② Access Point Transceiver (APT)
Connect a shielded Cat5e cable from the MXWAPT to network Port 1 of the MXWANI. If using an external gigabit switch, ensure Class 0 PoE provides at
least 6.5W of power to the APT. There is no power switch.
5
7
6
5
8
7
6
8
③ Networked Charging Station (NCS)
Connect the PS45 external power supply from the charger to an AC power source. Turn on the power switch.
①
Class 0 PoE
③
1
5
Fully Charge the Transmitters
2
6
3
7
②
4
8
Whenever possible, charge to full the MXW transmitters before an event. Transmitters can be charged in any networked charging station, even if it is
associated to another Group or on a separate network.
Battery Charge Times
Approximate Charge Times
Charger Type
Time to Full Charge* (hr:min)
Networked Charging Station (NCS)
2:00
USB Charger
•Powered On = 3:30
•Powered Off = 2:30
*Calculated with a new battery. Runtimes vary depending on battery health.
21