Download User and Installation Guide

Track
42
TRACK
The Track function allows recording the boat’s actual track.
It is possible to activate and deactivate the track function several
times during navigation; in this case, track segments will be automatically connected to each other to make one single track line.
Starting a track
To activate the Track function, press PAGE repeatedly until the menu
bar is displayed; select TRACK, the START option, and then press
ENTER to confirm the operation. A small circle will indicate the track
starting point.
Stopping a track
To deactivate the Track function, press PAGE repeatedly until the
menu bar is displayed; select TRACK, the STOP option, and then
press ENTER to confirm the operation.
Deleting a track
To delete a track, press PAGE repeatedly until the menu bar is displayed; select TRACK, the DELETE option, and then press ENTER
to confirm; a message will prompt the user to confirm the deletion
by pressing ENTER.
Marker
43
MARKER
The GEONAV allows entering and storing small symbols (markers)
to mark points of interest (e.g., submerged wrecks, fishing spots,
etc.). Each marker can be assigned a symbol and an 8-character
name.
CURSOR MODE
Inserting a marker
Move the cursor to the desired
point and press ENTER. Select the
desired marker shape and name
and then press ENTER to confirm.
A new marker will be automatically
entered at the position selected.
NOTE: Marker names are displayed starting
from the 32NM chart range.
Deleting a marker
Position the cursor exactly on the marker to delete, then press CLR
to confirm.
Modifying the shape and the name of a marker
Position the cursor on the desired marker; a window will display
the shape and the name of the current marker.
Press ENTER to confirm the marker editing and use the CURSOR key
to select the desired shape and name.
Press ENTER to confirm.