Download User and Installation Guide

Connections
12
Elite3
CONNECTIONS
Power supply cable
The car lighter adapter has a little lamp (LED)
that goes on if the car is correctly providing
power to the bracket.
If the lamp is off:
• verify that 12V voltage is available from
the lighter plug;
• open the adapter and check the fuse.
If the fuse is broken, replace it with a fuse
having the same electrical characteristics.
DO NOT USE ANY BYPASS CIRCUIT.
The fuse ensures that the special protection
circuit inside the plotter works properly in case
of accidental short-circuit, polarity inversion
and overvoltage. When removing the lighter
adapter, connections are the following:
red (or white) +(+12V)
black
- (ground)
Elite3
Connector and data cable
1. Auxiliary output voltage (Vaux)
red wire
Vaux +, 250mA pin
black wire GND
pin
2. Data input ext. GPS/DGPS
brown wire ext. GPS in +
pin
yellow wire ext. GPS in pin
3. Data output
violet wire Autopilot out + pin
white wire Autopilot out - pin
4. Data input depth sounder
blue wire
DS in +
pin
green wire DS in pin
SHIELD
pin
*
13
1*
2
3
4
5
6
7
8
9
Vaux voltage is the same as the plotter’s input voltage.
If sent by the autopilot, the following NMEA messages are transmitted to external devices: GGA - RMC - ZDA
The GEONAV will add the following messages: APA - APB - XTE RMB - BWC - GLL - VTG
The data cable is supplied together with the GEONAV plotter.
fuse
LED
WARNING: Once the installation is completed, always make sure that all wires are properly connected since wrong connections may damage the unit.