Download Quattrocycle

Quattrocycle BV



Move the part of the seat clamp that is located in the frame beam up
Fasten the 2 M8 bolts firmly
Tighten the seat clamp again
If the horizontal clamping is insufficient, follow these steps:
 Loosen the seat clamp
 Tighten the long M6 bolt under the frame beam somewhat
 Tighten the seat clamp again
If the seat is clamped with high force to the frame, but it can still move sideways, the
horizontal clamping only happens at the top or bottom of the clamp block. One can check
with a feeler gauge whether the clamp block is in contact with the frame beam over the full
height. If one side is not touching the frame beam, use the M8 nuts at that side to push the
clamp block further to the frame beam.
Check that the clamping force is sufficient to mount the seat stably on the frame.
Also check the connection of the child seats on the luggage rack.
Check the condition of the seat belts. Only use the child seats with properly working seat
belts.
3.8
Adjustment of the gears
In order to shift gears, the shifter cable needs to be well adjusted. You check the adjustment
by shifting to the second gear. On the gear shifter the yellow bracket inside should be exactly
between the two yellow stripes on the housing (see photo). The adjustment can be made with
a cable adjustment screw on the gear shifter.
User Manual Quattrocycle
10