Download AD-080GE Manual

Transcript
AD-080GE
Minimum PC requirements are as follows in order to fulfill the above conditions:
♦ Intel Core 2 Duo, 2.4 GHz or better
♦ At least 2 GB memory
♦ Video Card with PCI Express Bus x 16, VRAM better than DDR2 with 256 MB or more, and
display capability of 2560 x 1600
♦ Windows XP, SP2 (32bit)
♦ Functions such as screen saver and power save should not be used. Unnecessary applications
such as Word, Excel or others should not be used.
Note: Pentium 4 type PC is not recommended due to dependency on chip set bus performance.
10.2.2 Video data rate (network bandwidth)
The video bit rate for the AD-080GE in Continuous mode is:
Model
Pixel Type
Packet data volume
(assumes the packet size is 1428)
AD-080GE
MONO8
196 Mbit/s
Monochrome
MONO10_PACKED
294 Mbit/s
MONO12_PACKED
MONO10
392 Mbit/s
MONO12
AD-080GE
BAYRG8
196 Mbit/s
Color
BAYRG10Packed
294 Mbit/s
BYRG12Packed
BAYRG10,BAYRG12
725 Mbit/s
RGB8Packed
588 Mbit/s
RGB10V1Packed
784 Mbit/s
RGB10V2Packed
♦ In the case of using Jumbo Frames (16K), the packet data will be improved by 2%.
♦ For AD-080GE, the jumbo frame size can be a maximum 16020 Bytes (factory setting is 1428
Bytes). The NIC must also be set to support Jumbo Frames (see chapter 10.2.4).
♦ Based on the Pixel Type, the packet size may be automatically adjusted inside the camera to
its most suitable value .
To ensure the integrity of packets transmitted from the camera, it is recommended to follow
these simple guidelines:
1. Whenever possible use a peer-to-peer network.
2. When connecting several cameras going through a network switch, make sure it is
capable of handling jumbo packets and that it has sufficient memory capacity.
3. Configure inter-packet delay to avoid congestion in network switches.
4. Disable screen saver and power save functions on computers.
5. Use high performance computers with multi-CPU, hyper-thread and 64-bit CPU, etc.
6. Only use Gigabit Ethernet equipment and components together with the camera.
7. Use at least Cat5e and preferably Cat6 Ethernet cables.
8. Whenever possible, limit the camera output to 8-bit.
27