Download Neo900 NFC Subsystem Draft
Transcript
6 SWP As its name suggests, the Single Wire Protocol consists of a single wire (called SWIO) connecting the NFC subsystem and the SIM: VCC NFC SIM S1 (V) SWIO Secure Element S2 (I) The lower layers of SWP are defined in [23]. It is intended to convey configuration data and radio messages related to ISO 14443-3 type A [7] and NFC IP-1 [3] between NFC and the Secure Element in the SIM. Bidirectional communication is made possible over this single wire by using voltage signaling (signal S1) from NFC to SIM, and current signaling (signal S2) from SIM to NFC. Section 6.3 contains a detailed illustration of this process. 6.1 Voltages The supply voltage of the SIM card for SWP use has to be30 either class B or C, which are defined as 2.7–3.3 V and 1.62–1.98 V, respectively.31 The voltage on SWIO is confusingly defined as either absolute (class B and sometimes class C) or relative to VCC (class C).32 The following table summarizes the voltage levels at the card interface, for simplicity assuming VCC in class C to be exactly 1.8 V: Voltage Class VOH B C B C B C B C VOL VIH VIL 30 31 32 Absolute (V) Min Max 1.40 1.98 1.53 1.8 0 0.3 0 0.27 1.13 2.28 1.26 2.1 –0.3 0.48 –0.3 0.45 × 1.8 V Min Max 0.78 1.1 0.85 1 0 0.17 0 0.15 0.63 1.27 0.7 1.17 –0.17 0.27 –0.17 0.25 Section 7.1.1 of [23]. Sections 5.2.1 and 5.3.1 of [22]. Tables 7.3 and 7.4 in section 7.1.3 of [23]. 18