Download Neo900 NFC Subsystem Draft

Transcript
6
SWP
As its name suggests, the Single Wire Protocol consists of a single wire (called SWIO) connecting
the NFC subsystem and the SIM:
VCC
NFC
SIM
S1 (V)
SWIO
Secure Element
S2 (I)
The lower layers of SWP are defined in [23]. It is intended to convey configuration data and radio
messages related to ISO 14443-3 type A [7] and NFC IP-1 [3] between NFC and the Secure Element
in the SIM.
Bidirectional communication is made possible over this single wire by using voltage signaling (signal
S1) from NFC to SIM, and current signaling (signal S2) from SIM to NFC. Section 6.3 contains a
detailed illustration of this process.
6.1
Voltages
The supply voltage of the SIM card for SWP use has to be30 either class B or C, which are defined
as 2.7–3.3 V and 1.62–1.98 V, respectively.31 The voltage on SWIO is confusingly defined as
either absolute (class B and sometimes class C) or relative to VCC (class C).32 The following table
summarizes the voltage levels at the card interface, for simplicity assuming VCC in class C to be
exactly 1.8 V:
Voltage
Class
VOH
B
C
B
C
B
C
B
C
VOL
VIH
VIL
30
31
32
Absolute (V)
Min
Max
1.40 1.98
1.53
1.8
0
0.3
0
0.27
1.13 2.28
1.26
2.1
–0.3 0.48
–0.3
0.45
× 1.8 V
Min Max
0.78
1.1
0.85
1
0
0.17
0
0.15
0.63 1.27
0.7
1.17
–0.17 0.27
–0.17 0.25
Section 7.1.1 of [23].
Sections 5.2.1 and 5.3.1 of [22].
Tables 7.3 and 7.4 in section 7.1.3 of [23].
18