Download MX Series SCPI Programming Manual

CSW Series SCPI Programming Manual
:PAUSe
:TABle
:IHARmonics
:LEVel
:DWELl
:PAUSe
AMETEK Programmable Power
Set harmonics pause.
Select Individual harmonic table 1,2,3 or ALL.
Set interharmonics level.
Set interharmonics dwell.
Set interharmonics pause.
IEC413:STATe
This command will enable the IEC413 and initialize the associated data. Note that user
defined test levels for the USER group can only be programmed when the IEC413 state is
OFF.
Command Syntax
Parameters
Examples
Query Syntax
Returned Parameters
IEC413:STATe <state>
<ON|OFF|1|0 >
IEC413:RUN STAT ON
IEC413:STAT?
<boolean>
IEC413:RUN
This command will run the test. The parameters will define the section of test to be run.
Command Syntax
Parameters
Examples
Query Syntax
Returned Parameters
IEC413:RUN <group>
< ALL|GROup|RANGe|POINt >
IEC413:RUN ALL
IEC413:RUN?
<group>
IEC413:PAUSe
This command will cause the test to pause at the time the command is issued.
Command Syntax
Parameters
Examples
Query Syntax
Returned Parameters
IEC413:PAUSe <boolean>
ON|OFF|1|0
IEC413:PAUS ON
IEC413:PAUS?
<boolean>
IEC413:CLASs
This command will select the class. There are two predefined classes 2 and 3. Class 1 is
supported through the use of the USER defined class. Other tests levels can be set in the
USER class as well.
Command Syntax
Parameters
Examples
Query Syntax
Returned Parameters
CSW Series
IEC413:CLASs <class>
2|3|USER
IEC413:CLAS 3
IEC413:CLAS?
<class>
171