Download MX Series SCPI Programming Manual

CSW Series SCPI Programming Manual
AMETEK Programmable Power
OUTPut:IMMediate
This command opens the output relay without first programming the voltage down if the –
SNK option is installed and the CSW is in REGENERATIVE mode (REG:STAT ON). If not,
this commands works exactly the same as the OUTP[:STAT] command. This mode may be
used to simulate line loss in inverter applications. The query form returns the output state.
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
4.11.2
OUTPut:IMMediate<bool>
0 | OFF | 1 | ON
OFF
OUTP:IMM 1 OUTP:IMM OFF
OUTPut:IMMediate?
0|1
REG:STAT
REG:CURR
Output Protection
OUTPut:PROTection:CLEar
This command clears the latch that disables the output when an overvoltage (OV),
overcurrent (OC), overtemperature (OT), or remote inhibit (RI) fault condition is detected. All
conditions that generated the fault must be removed before the latch can be cleared. The
output is then restored to the state it was in before the fault condition occurred.
Command Syntax
Parameters
Examples
Related Commands
4.11.3
OUTPut:PROTection:CLEar
None
OUTP:PROT:CLE
OUTP:PROT:DEL
*RCL
*SAV
Output Remote Inhibit Modes
OUTPut:RI[:LEVel]
This command sets the remote inhibit level mode. Factory default is LOW, which requires a
contact closure to open the output relay. The level can be reversed by setting it to HIGH.
Once set, the RI level setting is retained each time the power source is powered up. Note
that this command is only implement with firmware revision 0.28 or higher. Lower firmware
revisions only provide the default LOW setting (CSW15 excluded).
Command Syntax
Parameters
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
OUTPut:RI:LEVel
LOW | HIGH
LOW
OUTP:RI:LEV HIGH
OUTP:RI:LEV?
<CRD>
OUTP
NOTE: When using the Remote Inhibit input, it will be necessary to disconnect any RI
connection to the CSW master unit when turning on the CSW master unit.
During initialization, the RI connection must be OPEN or initialization will be
halted with the message WAITING FOR AUXILIARY displayed on the LCD
screen.
OUTPut:RI:MODE
CSW Series
69