Download SBE 48 Hull Temperature Sensor

Section 4: Deploying and Operating the SBE 48
Note:
The SBE 48 has a buffer that stores
the most recent data sample.
Unlike data in the FLASH memory,
data in the buffer is erased upon
removal or failure of the battery.
Operating Commands
These commands are used by an external controller to request a sample from
the SBE 48.
TS
Take sample and transmit converted data.
Data is not stored in FLASH memory.
Do not send this command if SBE 48 is
logging data.
TSR
Take sample and transmit raw data.
Data is not stored in FLASH memory.
Do not send this command if SBE 48 is
logging data.
SLT
Transmit converted data from last sample
from buffer, and then take new sample.
Data is not stored in FLASH memory.
Do not send this command if SBE 48 is
logging data.
SLTR
Transmit raw data from last sample from
buffer, and then take new sample.
Data is not stored in FLASH memory.
Do not send this command if SBE 48 is
logging data.
TSS
Take sample, store in FLASH memory,
transmit converted data, and turn power
off. Do not send this command if SBE 48
is logging data.
TSSON
Take sample, store in FLASH memory,
transmit converted data. Do not send this
command if SBE 48 is logging data.
SL
Transmit converted data from last sample
from buffer.
24