Download Manual SC Master Lite

DMX-Out ...Output of DMX512 commands via cable adapter
SCK-MDMXE (accessory). As a standard, channels 1 to 6 can
be used (SC Net subaddresses from /3 and up). By adding the
optional DMX Upgrade Module output can be extended to
channels 1 to 64. Always the first 6 or 64 DMX addresses,
respectively are referred to, the address position cannot be
changed.
DALI-Out ...offers light control via a DALI bus. All 16 DALI
groups are available, but there is no differentiation between
subaddresses. The first 16 DMX channels are used for programming in Wings Platinum.
MIDI-Out ...for output of MIDI timecode which was previously
supplied to the CUE-IN connector as SMPTE timecode . This
function is required for timecode synchronization in Wings
Platinum. Further information can be found in the Wings
Platinum Online Help.
IR-Out ...allows transmission of IR commands via a transmitting diode. This function is only available for shows produced
with Wings 4.11.
LmpFail ...the first switch output AUX 1 is activated when the
projector lamp is defective. This function may, for example, be
used to indicate a slide projector lamp failure by a pilot lamp in
a distant room lighting up. It requires Ektapro, Leica RT and
Simda projectors featuring the corresponding lamp failure
function.
HighLgt (High Light Function)
Here you specify whether and how the HighLight Function of
Ektapro and Leica RT projectors it to take effect. With a setting
SC MASTER LITE
The Menu Items • 71