Download ang.

Appendix
D
Function Block Faceplate Controls
Introduction
RSLogix 5000 programming software includes faceplates (controls) for some
of the function block instructions. These faceplates are Active-X controls that
you can use in RSView SE or RSView32 software or any other application that
can act as an Active-X container. In the case of RSView SE software, the
faceplates communicate with the controller via RSLinx Enterprise software. In
the case of RSView 32 or other third-party applications, the faceplates
communicate with the controller via the RSLinx OPC server.
IMPORTANT
RSLogix 5000 programming software cannot be a
container for the faceplates. You must use software such as
RSView SE or RSView 32 software as a container for the
faceplates.
These instructions have faceplates:
Instruction:
See page:
Alarm (ALM)
D-6
Enhanced Select (ESEL)
D-8
Totalizer (TOT)
D-9
Ramp/Soak (RMPS)
D-11
Discrete 2-State Device (D2SD)
D-14
Discrete 3-State Device (D3SD)
D-16
Enhanced PID (PIDE)
D-18
You configure the faceplates through property pages that you open through
the container application, such as RSView SE or RSView32 software.
All faceplates have four property pages in common.
•
•
•
•
1
general
display
server
fonts
Publication 1756-RM006D-EN-P - May 2005