Download Arbitrary Waveform Generator User Manual - Technica-M
Transcript
5.Front Panel Operation Figure 5-2: Set the frequency using number keys To Set the Amplitude Press F2 , confirm whether the "Ampl" menu item is highlighted; if not, press F2 to switch into "Ampl". In the Parameter bar 2, a cursor appears under the value of amplitude. Use the knob or the number keys to set the desired value. To Set the Offset Press F3 , confirm whether the "Offset" menu item is highlighted; if not, press F3 to switch into "Offset". In the Parameter bar 2, a cursor appears under the value of offset. Use the knob or the number keys to set the desired value. To Set the High Level Press F2 , confirm whether the "Hi_Level" menu item is highlighted; if not, press F2 to switch into "Hi_Level". In the Parameter bar 2, a cursor appears under the value of amplitude. Use the knob or the number keys to set the desired value. To Set the Low Level Press F3 , confirm whether the "Lo_Level" menu item is highlighted; if not, press F3 to switch into "Lo_Level". In the Parameter bar 2, a cursor appears under the value of offset. Use the knob or the number keys to set the desired value. To Output Square Signals Press button to call the user interface of Square signal, the Square waveform parameters can be set by operating the Square setting menu on the right. The parameters of Square waveform are: Frequency/Period, Amplitude/High Level, Offset/Low Level, Duty. You can operate the menu by using the menu selection buttons on the right. To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "To Output Sine Signals" on P11. The frequency range is 1μHz~50MHz; the period range is 20ns~1Ms. 12