Download FT-2000 - Mobinet

REAR PANEL
TX REQ Jack
EXT SPKR
When this RCA jack shorted to ground, it puts the FT2000 into the transmit mode, and sends out a steady
CW carrier, for linear amplifier or manual antenna tuner
adjustment.
This gold-plated two-contact output jack provides receiving audio from the Main (VFO-A) and Sub (VFOB) receivers for an external loudspeaker or speakers,
such as the SP-2000. Inserting a plug into this jack
disables the internal loudspeaker. Impedance is 4 ~ 8
Ohms.
TX GND Jack
This RCA jack’s center pin is closed to ground while
the transceiver’s transmitter is engaged. It may be used
for control of a peripheral device, most typically a linear amplifier. To enable this jack, please set Menu item
“135 tGEn ETX-GND” to the “EnA” (Enable) selection.
The relay circuit of the FT-2000 used for this jack is
capable of switching AC voltage of 100 Volts at up to
300 mA, or DC voltages or 60 V at 200 mA or 30 V at
up to 1 Amp.
+13.8 V Jack
µ-TUNE Jack
This 10-pin MINI-DIN jack used for control of the
optional RF µTuning Kit.
DMU Jack
This 8-pin MINI-DIN jack accepts a cable connected
to an optional DMU-2000 Data Management Unit.
PGM (PROGRAM) Jack
This coverd 9-pin MINI-DIN jack is used at the factory. Please do not connect any equipment to this jack.
This RCA output jack provides regulated, separately
fused 13.8 VDC at up to 200 mA, to power an external
device such as a packet TNC. Make sure your device
does not require more current (if it does, use a separate
power source).
CAT Jack
AF OUT
KEY Jack
This gold-plated 3-contact jack provides dual-channel
low-level receiver output, for recording or external amplification. Peak signal level is 300 mVp-p at 10 kOhms. Main band (VFO-A) receiver audio is on the
left channel (tip), and sub band (VFO-B) receiver audio is on the right channel (ring). A stereo amplifier or
recorder is recommended, to record each receiver’s
audio separately when dual reception is enabled (audio from either receiver, or both, may be used via this
jack). The front panel [AF GAIN] knobs do not affect
the signals at this jack.
This 1/4-inch phone jack accepts a CW key or keyer
paddle. A 2-contact plug cannot be used in this jack.
Key-up voltage is +5 V, and key-down current is 1 mA.
Plug wiring is shown on page 15, and this jack may be
configured for keyer, “Bug,” “straight key,” or computer keying interface operation via Menu item “054
A1A R-TYPE.”
REM (REMOTE) Jack
By plugging in the optional FH-2 Remote Control Keypad to this gold-plated jack, direct access to the FT2000 CPU is provided for control functions such as
contest memory keying, plus frequency and function
control.
FT-2000 OPERATING MANUAL
This 9-pin serial DB-9 jack allows external computer
control of the FT-2000. Connect a serial cable here
and to the RS-232C COM port on your personal computer (no external interface is required).
DC IN Jack
This 4-pin connector requires a 13.8-volt supply capable of 22 amperes continuous duty.
Typically, you will connect the DC OUT plug to this
jack. For DC operation, use the optional DC Cable
(P/N: T9023725) with a 25 A fuse installed.
Page 33