Download READ FIRST!

33154_WlessKeypad
7/29/04 6:24 PM
Page 2
System Requirements
Using the Wireless Keypad Calculator
* Microsoft® Windows® 98/Me/2000/XP compatible
Turning the keypad Off and On
* One available USB port
To turn on the keypad, press the CE/AC key, located directly above the number
seven key. The keypad starts in calculator mode and displays “0”.
Installation
Connecting to Windows98/ME Operating System
1. Plug the USB receiver into the USB port of your PC (the USB receiver is located
on the back of your Wireless Keypad Calculator and identified by the red
light—simply slide out the USB receiver to remove it from its storage slot).
2. The Add New Hardware Wizard appears.
3. Click Next. The locate driver screen appears.
The keypad automatically turns itself off after two minutes of non-operation, or
you can press the CE/AC key for two seconds and it will turn off.
ID setting
Plug the USB receiver into your notebook’s USB port and turn on the Wireless
Keypad Calculator. The LED on the receiver will start flashing. Press the ID
button under the keypad, the LED will turn off. This means the ID setting is now
accomplished.
4. Select “Search for the best driver for your device. (Recommended),” and then
click Next, The wizard searches for the appropriate device driver.
5. Click Finish to complete the driver installation.
You are now ready to begin using your Wireless Keypad Calculator.
Connecting to Windows 2000/XP Operating System
1. Plug the USB receiver into the USB port of your PC (the USB receiver is located
on the back of your Wireless Keypad Calculator and identified by the red
light—simply slide out the USB receiver to remove it from its storage slot).
2. The Found New Hardware Wizard appears and the OS will install the driver
automatically. No other steps are necessary.
You are now ready to begin using your Wireless Keypad Calculator.
2 • Wireless Keypad Calculator
Wireless Keypad Calculator • 3