Download OEM Manual

Transcript
SYSTEM OVERVIEW:
Parameter Cloning and Software Update
Parameters or the complete software can be updated at the OEM site without the need to
open the housing of the CURTIS MC-2 devices. Simply plug the PC Programming
Station into the wheelchair and update the desired devices.
Choose Your Controller
The CURTIS MC-2 controller is available with an integrated driving light module or
with integrated actuator outputs. Two power versions are available: 60 and 100 Amp.
MC-2 System
The figure below shows all the available modules connected to the MCP bus.
MCP-
Fig. 1: MC-2 System
Overview
BUS
CONTROLLER
STANDARD
CONTROLLER
with
ACTUATORS
HANDCONTROL
TASH-DEVICES
.
LCDDISPLAY
STAND
ALONE
JOYSTICK
HEAD
CONTROL
CONTROLLER
with
ACTUATORS
AND LIGHT
SEATMODULE
M
MOTOR RIGHT
M
MOTOR LEFT
M
MOTOR RIGHT
M
MOTOR LEFT
M
ACTUATORS 1...4
M
MOTOR RIGHT
M
MOTOR LEFT
X
LIGHT/INDICATORS
M
ACTUATORS 1...2
M
MOTOR 1
M
MOTOR 5
SIP&PUFF
ECUMODULE
DEVICE 1
DEVICE 8
HANDHELD
PROGRAMMER
INTERFACE
to MCP-BUS
FUTURE
MODULES
PC-PROGRAMMING
STATION
!
CAN/RS232
GATEWAY
PROGRAMMING
DEVICES
INPUT
DEVICES
USER INTERFACE
Curtis MC-2 Manual
THIRD PARTY
INPUT/OUTPUT DEVICE
CHARGER
DISPLAY
MODULE
INTERFACE TO WEELCHAIR/
ENVIRONEMENT
5