Download OEM Manual
Transcript
SYSTEM OVERVIEW: Parameter Cloning and Software Update Parameters or the complete software can be updated at the OEM site without the need to open the housing of the CURTIS MC-2 devices. Simply plug the PC Programming Station into the wheelchair and update the desired devices. Choose Your Controller The CURTIS MC-2 controller is available with an integrated driving light module or with integrated actuator outputs. Two power versions are available: 60 and 100 Amp. MC-2 System The figure below shows all the available modules connected to the MCP bus. MCP- Fig. 1: MC-2 System Overview BUS CONTROLLER STANDARD CONTROLLER with ACTUATORS HANDCONTROL TASH-DEVICES . LCDDISPLAY STAND ALONE JOYSTICK HEAD CONTROL CONTROLLER with ACTUATORS AND LIGHT SEATMODULE M MOTOR RIGHT M MOTOR LEFT M MOTOR RIGHT M MOTOR LEFT M ACTUATORS 1...4 M MOTOR RIGHT M MOTOR LEFT X LIGHT/INDICATORS M ACTUATORS 1...2 M MOTOR 1 M MOTOR 5 SIP&PUFF ECUMODULE DEVICE 1 DEVICE 8 HANDHELD PROGRAMMER INTERFACE to MCP-BUS FUTURE MODULES PC-PROGRAMMING STATION ! CAN/RS232 GATEWAY PROGRAMMING DEVICES INPUT DEVICES USER INTERFACE Curtis MC-2 Manual THIRD PARTY INPUT/OUTPUT DEVICE CHARGER DISPLAY MODULE INTERFACE TO WEELCHAIR/ ENVIRONEMENT 5