Download IT. S811 Soft Starter

Transcript
IT. S811 Soft Starter User Manual
November 2006
0x80B8
(32952) Phase Loss Duration/Delay (0.1 seconds)
Size:
2 bytes
Default:
0.5 sec
Description: Unsigned integer sets duration in tenths of seconds that a phase loss
condition must persist before a Phase Loss Fault is generated.
0x80C0
(32960) Motor Control Command Missing Timeout (milliseconds)
Size:
2 bytes
Default:
2000 milliseconds
Description: Unsigned integer.
Every device that produces a Motor Control byte gets a timer
assigned to it. When a device fails to refresh its Motor Control byte
the timer will expire. When the timeout occurs, a Missing Motor
Control Device Fault is generated.
0x80C3
(32963) Temperature Sensor Fault Enable
Size:
1 byte
Default:
1 (Enabled)
Description: Enables temperature sensor failure detection. Temperature Sensor
Fault indicates that sensor has failed either by being disconnected or
reporting an invalid temperature.
0x80C4
(32964) SCR Not Firing Fault Enable
Size:
1 byte
Default:
1 (Enabled)
Description: Enables detection of SCR (thyristor) failure to conduct current when
fired (gated)
0x80C5
(32965) SCR Shorted Fault Enable
Size:
1 byte
Default:
1 (Enabled)
Description: Enables shorted SCR detection.
0x80C6
(32966) Input Level Sense Enable
Size:
1 byte
Default:
1 (Enabled)
Description: Enables DC voltage level detection at the S811 Run1 terminal block
input.
0 – Run1 Edge Sensing
1 – Run1 Level Sensing
0x80C8
(32968) Under Voltage Fault Level (%)
Size:
1 byte
Default:
90% Motor Rated Volts
Description: Unsigned integer.
The S811 monitors the minimum RMS value of the incoming three
phase voltages. The unit will trip if the Under Voltage Fault is enabled
and the minimum RMS value drops below the Under Voltage Fault
Level or 80V AC, whichever is greater, for longer than the Under
Voltage Fault Duration. Note that the S811 will not generate an under
voltage trip when the motor is starting. The fault is only active when
the unit is operating in bypass.
I-14
For more information visit: www.EatonElectrical.com
MN03902002E