Download IT. S811 Soft Starter

IT. S811 Soft Starter User Manual
November 2006
0x804A
(32842) Auto Reset Enable
Size:
1 byte
Default:
0 (Disabled)
Description: Enables the auto fault reset function. An auto reset will be performed
after the thermal memory has cooled below 75% and all other fault
conditions have been corrected. This parameter is displayed as Reset
Mode in the DIM
0x804B
(32843) Start Method
Size:
1 byte
Default:
0
Description: Unsigned integer which sets the S811’s starting method:
0x00 – Voltage Ramp Start
0x01 – Current Limit Start
0x02 – Reserved
0x03 – Pump Start (option)
0x04 – Reserved
0x804E
(32846) Motor Communication Loss Action
Size:
1 byte
Default:
0x00
Description: Determines motor action in the event of a communications timeout
in network communications. This parameter only applies when the
node is on line and in Auto mode. The following values are allowed:
0x00 = Auto Stop – go to auto and stop
0x01 = Auto Run1 – go to auto and Run1 1
0x02 = Auto Run2 – go to auto and Run2 1
0x03 = Hold Last – hold last state
0x04 = Local Stop – go to local and stop
0x05 = Local Run1 –go to local and Run1 1
0x06 = Local Run2 – go to local and Run2 1
0x07 = All Stop (fault)– leave in last control mode (local or auto) and
stop 2
Note 1: Warning, these actions may cause the S811 to start once
network communications are restored.
Note 2: All Stop causes a fault and needs a reset to clear.
0x804F
(32847) Motor Rated Volts (volts)
Size:
2 bytes
Default:
480 volts
Description: Unsigned integer set to match the incoming line voltage. This setting
calibrates the Over Voltage and Under Voltage Faults
0x806C
(32876) Firmware Version List
Size:
4 bytes
Default:
N/A
Description: Unsigned integer identifies firmware versions of all firmware
components of the S811. Consists of 2 2-byte elements.
0x806D
(32877) Hardware Version List
Size:
2 bytes
Default:
N/A
Description: Hardware version of all components of the system
MN03902002E
For more information visit: www.EatonElectrical.com
I-11