Download IP camera tester - Security Merchants

Note:
1 .Don’t input any power into the “DC12/2A OUTPUT” port of the CCTV tester to avoid destroy.
2. Don’t output this DC12V/2A power to the power input port of the CCTV tester to avoid destroy
3. When the requirement of the camera is higher than 2A, the CCTV tester will enter protection mode.
Disconnect all the connections of the CCTV tester and then connect the CCTV tester with power
adaptor to resume the CCTV tester.
4. Before turn on the power output, Please make sure the IP camera support PoE powered. Otherwise
damage IP camera.
5. When use PoE output, UTP cable must be Straight-through, and cannot short-circuited, or it will
damage the instrument!
6. Make sure the tester is full charged or more than 80%, or it will shows low power and cannot
supply power.
3.3.23 Application tools
It contains audio record, network bandwidth test tools now .Some application tools can customize
according customer’s requirements.
Click icons
to enter
Page.64.