Download ESPLXME-ET Controller

FOrient the cartridge so that the two bottom hinges fit into the
hinge openings at the bottom of the cartridge bay. Then gently
swing the cartridge up into place, snapping the top-latch.
NOTE: Position the wires so that they match up with the cable
bb
routing channel in the front panel.
NOTE: When connecting the ET Manager Cartridge, the front
bb
panel may display a Warning with a prompt to select OK to
upgrade the controller. Select OK, and a note appears that
reads “The display will be blank for approximately 3 minutes”.
Do not power down the controller until the firmware flash has
concluded. When complete, factory defaults will load and the
screen will display Communications None Installed until the
ET Manager Receiver is connected to the ET Manager Cartridge.
HClose the front panel.
F
GRoute the Antenna Cable and ground wire through the cable
channel on the back of the controller front panel.
CAUTION: Ensure that the antenna cable and ground wire do
dd
not contact the transformer directly. Heat from the transformer
may damage the insulation.
g
176
ESPLXME-ET Controller
ESPLXME-ET user-manual (670503-01) artwork_120716.indb 176
7/16/2012 3:40:58 PM