Download Manual - Korenix

JetWave 2310/2311 Series User Manual
After applied, the Web GUI will show “Change settings successfully”. Click “OK” and then
you can see the new entry shown in the below table.
•
Destination Port Filtering
Entries in this table are used to restrict certain ports of data packets from your local network to
Internet through the Gateway. Use of such filters can be helpful in securing or restricting your
local network.
Select “Enable Destination Port Filtering”, type the “Port Range” of below “Protocol” type,
the protocol type can be UDP, TCP or Both. Type the “Comment” (note for the entry) and
then press “Apply” to activate the settings.
After applied, the Web GUI will show “Change settings successfully”. Click “OK” and then
you can see the new entry shown in the below table.
4.2.7
Inbound Firewall
“Inbound Filtering”: Inbound Filtering is used to restrict any access from Internet to the LAN.
Only the applied entries in Exception list can access the LAN from Internet through the gateway.
Enable Inbound Firewall: After enabled inbound firewall, it means that all the IP address
from the Internet can NOT access the LAN through the gateway.
Exception: The exception table allows you to configure the exception list.
Src IP Address: The entry allows you to configure the source IP address from Internet.
Page 41