Download caution - Suport

„ About sytem configuration
The following describes the system configuration of each connection included in this manual.
The configuration of
equipment connected
to GOT is shown.
The cable connecting
the GOT to the
equipment is shown.
The configuration of
the GOT connected to
equipment is shown.
For the option devices,
refer to the following.
1.3 Option Devices for
the Respective
Connection
QCPU
RS-422 connector
conversion Cable
GOT
Connection cable
Indicates the connection diagram
number of cables to be prepared by
the user.
Refer to the connection diagram
section in each chapter.
A representative example
of the system configuration
is described with an
illustration.
Indicates the maximum distance between
the PLC and GOT.
System Configuration Examples
(When connecting the PLC [MELSEC-Q] and GT16, with RS-422 cable)
Indicates the commercially available
cable models that can be used.
1) Connect the RS-422 conversion cable [FA-CNV2402CBL] to the [MELSEC-Q].
2) Connect the option [GT16-C02R4-9S] to [GT16].
3) Connect [MELSEQ-Q] and [GT16] with the connection cable [GT01-C30R4-25P].
Since the above page was created for explanation purpose, it differs from the actual page.
A - 19