Download User Manual - G
Transcript
FIRST FIXTURE’S IP CODE VALUE = (VALUE OF THE FORMER IP CODE) + (CHANNEL ON THE CONTROLLER) Note: The first moving head’s starting IP code is 001. Channel number on the controller should not be less than the channel number on the moving head. 6. MOVING HEAD IP FUNCTION SELECTION There are 16 IP function selections on the G-Lites Moving heads. These functions could be selected by the operation panel. 7. DISPLAY MENU MAP: N Description Default 1 2 DMX setting address setting PAN normal/anticlockwise 180 degree setting TILT normal/anticlockwise setting Extend/compress channel setting PAN/TILT run speed setting total 1-10 level Lamp on/controller turn on setting Display normal/inversion mode Fixture working hours Key-press restoration enactment Interior electronic restoration enactment Spare Self-test Master/slave mode Restore default setting of leave the factory Dimmer function Temperature contrast d.001 Pa.rI Up/Down letter d.512 PA.LE TI.Dn 16 bit SPd 6 TI.Up 8 bit SPd 1/10 LAP y dIP.P H000 rESt rST.I LAP n dIP.A F1-N F2-N F3-N ------- F1-Y F2-Y F3-Y ------- dn-r T.Nar dn-n T Hot / T.Col 3 4 5 6 7 8 9 10 11 12 13 14 15 16 www.g-lites.com key rST.I 13