Download TSC1 Technical Manual

Transcript
TSC1 Technical Manual
Using the TSC1
Interference due to RF emissions
The TSC1 resistive touchscreen controller works by driving a potential difference across
two sides of the touch panel and then measuring the resulting voltage on another of the
panel wires when a touch is made. If used in an area where there are high RF
emissions, noise may be induced onto the touchscreen interface cable, resulting in an
inaccurate response or even a complete failure of operation.
The backlight inverters used with TFT flat panel displays can be a source of RF
interference. It is recommended that the backlight inverter and its cabling be kept as far
as possible from the TSC1 and its cabling. The inverter cabling and the TSC1
touchscreen interface cable should not be routed together.
© 2005 Arcom Issue E
26