Download - Solarclarity

Malfunctions
Performing a restart
1 Press the reset button e.g. with an open paper clip.
 LED 1 goes out.
3 Release the reset button.
 After approx. 5 seconds LED 1 illuminates again.
 After approx. 20 seconds LED 1 and LED 2 start to flash, the
device restarts with the set values.
4 Wait until normal operation has recommenced and then close the
cover.
Caution
Do not perform a restart by pulling out the power plug!
9.2.1 Obtaining information from the internet
You can also obtain support for operating the device or the settings on
our internet site under the following URL:
http://www.solar-log.com/en/service-support/technical-support.html
Here you will also find additional product information and manuals
available for download.
9.2.2 Informing a specialist technician
500
Should problems occur with the Solar-Log that are not able to be
remedied using them measures described, we recommend that you
contact your solar technician or our customer service.
The contact addresses for our customer service can be found on the
back of the envelope.