Download OPERATING MANUAL

STRIDER MD
Adjusting the seat height
The seat height (h) is adjusted using the
four holes (B1 - B4) in the seat support.
Adjusting the seat
support
➨ Pull the seat support (6) out as far as
the required height until the correct
hole (B1-B4) appears in the seat tube
hole (7).
➨ Push the clamping bolts (3) with the
form shim (5) into the seat tube from
the front.
tighten the clamping
bolt
➨ Screw the self-locking nut (4) and tighten
it (size 12 mm). While doing this, prevent
the clamping bolt (3) from turning using a
second ring spanner (size 12 mm).
21
Issued: 24.02.2005