Download OPERATING MANUAL

STRIDER MD
Repairs - mechanics
18.3.4 Replacing the inner tube / tyre
➨ Remove the damaged wheel.
Deflating the tyres
➨ Unscrew the valve cap (1).
➨ Carefully press the valve plunger (a)
inwards with a screwdriver until the
inner tube is completely deflated.
Risk of accidents!
• Dismantle the wheel rims only
when the inner tube is completely
deflated.
Dismantling the wheel rims:
➨ Loosen the three nuts (2) with a socket
spanner (size 12 mm) and remove
together with the lock washers (3).
➨ Separate the wheel hub (4; rear wheel) /
brake drum (5; front wheel) from the
wheel rim.
➨ Remove the inner wheel rim (6) from the
tyre.
➨ Remove the outer wheel rim (7) from the
tyre.
➨ Pull the inner tube (8) out of the tyre (9).
Reassembly:
➨ Push the inner tube (8) into the tyre (9).
➨ Inflate the inner tube until it is unfolded.
➨ Place the outer rim (7) in the tyre, at the
same time make sure the valve cutout is
above the inner tube valve.
➨ Place the inner rim (6) in the tyre and
align the fixing holes.
➨ Place the wheel hub (4) / brake drum (5)
in the inner wheel rim.
➨ Locate the lock washer (3) screw on the
nuts (2) and tighten evenly.
➨ Inflate the tyre to the correct pressure
(18 - 20 hPa / 1.8 - 2.0 bar / 25 - 28 PSI).
76
Issued: 24.02.2005
Reassembling the
Strider wheel