Download User Manual

22
HV_D[0]
23
HV_D[1]
24
HV_D[2]
25
HV_D[3]
26
HV_D[4]
27
HV_D[5]
28
HV_D[6]
29
HV_D[7]
30
+5V/100mA
Power
31
READY
O
PMC is ready for a step
Active HIGH
32
RAMPING
O
PMC is ramping the HV_out
Active HIGH
33
STEP_CNT
O
A 64 μs pulse is generated at
the fast edge of sawtooth.
34
HC
O
Hand-Control selected
0=Computer-Control / 1=Hand-Control
35
OVR_CUR
O
Overcurrent at the HV_out
Active HIGH
Ramping (by HCU or S_STEP, C_STEP) is
still possible.
36
OVR_HEAT
O
Overheat of the PMC
Active HIGH
Ramping is disabled and HV is switched
off automatically.
37
GND
Power
Figure 12:
I
0V = 0
8bit digital HV-set value of the
sawtooth output voltage
0000'0000: HV = ±0V
:
1000'0000: HV = ±200V
1000'0001: HV = ±201.6V
:
1111'1111: HV = ±400V
+5V supply for external
circuits
max. 100mA (internal 200mA multifuse)
Pulse to count the number of steps (works
also if Hand-Control Unit is active)
0V / Housing PMC
The table with all I/O signals available on the Computer-Control connector. A short
description and some details are also given; for better and deeper explanations see the
chapter Computer-Control.
PMC User's Manual (SP 869)
Physics Basel
Page 17 of 19