Transcript
PH9 GENERATOR USER MANUAL 1. Before being used for the first time, rinse the PH9 Generator with water. 2. Fill the PH9 Generator with water, turn the bottle up side down and back a few times and within a few minutes the water pH level starts to rise, how long time it takes to reach it’s maximum level depends on the quality of the original water. For Swedish tap water 2-3 hours is recommended. 3. You can add your supplements to the PH9 Generator for a stronger effect and faster absorption. 4. If the bottle is used 3 times per day, the effect will last at least 2 years (much longer if only water is used with the bottle). IMPORTAT TO KNOW 1. Never use the PH9 Generator with medicine intake. 2. Never use the PH9 Generator to consume alcohol. 3. Never fill the PH9 Generator with HOT water (above 55 degrees celsius). 4. Never put the PH9 Generator into a microwave. 5. If you are uncertain whether to drink alkaline water, contact your doctor for advice. 6. Do not use with deionized water. Osmosis filtered water needs to have a mineral filter. RECHARGE 1. Do not keep water in the PH9 Generator for more than 3 consecutive days. This will reduce its ability of quick alkalization for new water poured into it. 2. LIGHT RECHARGE takes place when you keep the PH9 Generator clean and dry over the night for 12hrs. 3. FULL RECHARGE takes place when you keep the PH9 Generator clean and dry for 24hrs. We recommend FULL RECHARGE at least once a week for frequent daily users. 4. For professional users to obtain maximal results, use two containers and always keep one bottle on FULL RECHARGE. CLEANING THE PH9 GENERATOR 1. Wash the PH9 Generator with tap water, dish soap and dish brush when you have used it with supplements. 2. It is important to put the PH9 Generator upside-down after cleaning so it will dry completely inside. 3. When used with tap water containing calcium, which cause lime scale residue, we recommend that the PH9 Generator be washed out with alcohol once a month. 4. Never put the PH9 Generator in dishwasher (it may damage it or reduce lifespan). ADDITIONAL INFORMATION 1. PH9 Generator creates alkaline water that has a PH level between PH 8.7-9.0. 2. The PH9 Genrator can be used with other beverages to keep fresh for a longer time. 3. To test the water pH-level, make sure to use approved drops containing: Phenolphthalein or Fenolftalein. www.ph9sales.com
