Download LDN101 - OMEGA Engineering

The structure of the file is as shown below.
;This is an example of a ORBITxy.DAT file
;It holds the set-up data for a complete network of Orbit Modules
;
;Header comment lines must start with a ”;” there can be as many comment lines
;as required as long as they are not placed between Address - Identity lines
;
;Address - Identity line structure:- aa-iiiiiiiiii cccccccccccccccccccc
;a=address, i=identity [10 characters] c = comment [up to 20 characters maximum]
;
01-IDENTITY01 comment for address1
020304050607080910111213-IDENTITY02 comment for addr 13
1415161718192021222324-IDENTITY03 comment for addr 24
252627282930315.2.2 Running ORBINST.EXE
To run the ORBINST.EXE program type: ORBINST /CA100
<return>
The program will then search the current directory for ORBITxy.DAT files. Before the appropriate Orbit
Network is initialized the ORBITxy.DAT file is checked for syntax errors. Note that syntax errors can only occur
if the ORBITxy.DAT file has been created or edited outside of the ORBSET environment. If any Orbit Module
identities referred to in the ORBITxy.DAT file cannot be found during the initialization of the Orbit Network, the
error will be reported to the screen.
Note: /CA100 is the default network card base address and will be used if no extension is used. For more
information on base addresses refer to the section on Installing The Orbit Network Card.
LDN101
M-3338 02/99
Page 21 of 54