1
Download ARM Cross Development with Eclipse
Transcript
These will not work when you plug in a JTAG debugger, such as the Wiggler. When the DBGSEL line is pulled high, such as inserting the Wiggler, debug mode is entered and these three I/O pins are re-assigned as the Pipeline Status bits. One solution is to add a small LED to the TiniARM Controller Interface Board. Since P0.7 was used in the LPC2106_Blink_Flash project described previously, this I/O port can be brought out on the TiniARM and easily attached to an LED through the J8 connector on the Controller Interface Board.
