Download User Manual - Trango Systems

speed SYNTAX speed <bandwidth> <modulation> <bandwidth>: 4,5,7,8,10,12,14,20,25,28,30,40,50,56,80 <modulation>: qpsk, qam16, qam32, qam64, qam128, qam256 Default: bandwidth 30, QAM32 Configuration Storage: Yes speed without any parameter will display the current speed setting DESCRIPTION Load the corresponding the modem binary and configure Tx and Rx bandpass filters. The speed command will also configure the modem protection mode based on the system_mode configuration. Only when the 1+1 HSB mode is set, the modem may be configured as working or protection mode. Binaries selection for the speed command is based on 5 different configuration: tdm_mode, acm enable, modulation and bandwidth. Making changes via the tdm_mode, or acm enable commands will require a subsequent re‐load of the speed setting for proper operation. Speed Setting (Actual BW) Modulation IF RX LPF (MHz) Trango Systems, Inc. IF TX Total Symbol LPF (MHz) Capacity Rate GigaPlus User Manual Rev 3.0 License key 185