Download WebRelay Users Manual

Transcript
Revision 3.8
WebRelayTM Users Manual
can operate the gate from another room using a web browser. Another option (not shown here), is to
connect another pushbutton switch to the input of a second WebRelay TM device in a room across the
building. The second device could be configured to send control messages to the first device each time the
new pushbutton is pressed. As a result, there is a second pushbutton that could operate the gate.
2.2.4 Optically-Isolated Input Connection
The optically-isolated inputs can be used to control the internal relays, control remote relays (over the
network), or simply to monitor the state of a discrete device. To use these inputs, connect a DC control
voltage directly to the input and ground, and set up the function of the input using the configuration pages. A
current limiting resistor is provided internally, so no external resistors are required as long as the maximum
input voltage is not exceeded. If an AC signal, or a signal greater than the rated input voltage needs to be
detected by the WebRelay™, use a signal conditioner to convert the signal to a DC signal within the input
range.
Connecting "dry contacts" to the optically-isolated inputs:
A dry contact switch can be connected to the input of the WebRelay™. One side of the contact is connected
to +5V OUT, the other side is connected to Input+, and a jumper cable connects the V IN- to the INPUT-.
When the contact is closed, it applies 5V to the input terminals.
Xytronix Research & Design, Inc.
page 20