Download Model 8670 SureFlow

Chapter 2
How To Use This Manual
General
Discussion
WARNING:
Programming the
Instrument for the
First Time
This manual is divided into four parts. Each part is designed to cover a particular
area of interest for different people. It is recommended that everyone read the
entire User's Guide; however, the following guidelines reference the manual
sections which are relevant to your situation:
Part
Title
Who Should Read
Chapters
One
Introduction
Everyone
1-3
Two
Programming the
Instrument
Programmers
Start-up Personnel
Installers
Facility Engineers
Maintenance Personnel
4-8
Three
Diagnostics and
Maintenance
Service Personnel
Maintenance Personnel
Facility Engineers
9-11
Four
Appendices
Design Engineers
Consulting Engineers
Facility Engineers
Every SUREFLOW is factory calibrated; the sensor and controller must therefore
be kept as a matched set.
If you are unfamiliar with the TSI SUREFLOW products and you need to program
the instrument, it is recommended that you read Chapters 1-8. Part One (Chapters
1-3) provides an overview of the instrument. The instrument block diagram
shown in Figure 3 of Chapter 4 is an excellent reference to use while
programming the instrument.
Part Two (Chapters 4-8) details how the SUREFLOW is programmed and
describes the items in the SETPOINTS, CONFIGURE, CALIBRATION,
and CONTROL menus. This Part is designed to be used as follows: User must
read Chapter 4, "Programming the Instrument," first. It shows the user how to
use the keypad to program the instrument. Once the user is familiar with the
methods needed to program the instrument, the same procedure (i.e., sequence
of keystrokes) is used to program any item of the SUREFLOW. The subsequent
chapters (5-8) describe the different menu items, but have few step-by-step
keystroke procedures. If you are having difficulties programming your
SUREFLOW, please contact your authorized TSI Manufacturer's Representative
or TSI.
5