Download TECHNICAL SERVICE MANUAL

Transcript
COLOR MONITOR TESTS
The diagnostic tests for the Color Monitor require no interaction, but do require
that you pay close attention to the screen when the tests are being run. Since
these tests are not self-checking, it is up to you to verify their accuracy for
yourself.
If the Processor's video controller submodule tests are run with the Color
Monitor, the tests appear as a monochrome display. This is normal, and does not
indicate any problem with the Color Monitor.
For further information, see the "Video Controller Test" subsection in Section 3,
"Processor Modules."
The Color Monitor tests cannot be run with a Monochrome Monitor attached to your
workstation.
When the Color Monitor is marked during the selection process and you press
RETURN, the diagnostics queries you only twice:
Delay? (1-10)
This question allows you to speed up or slow down the pace at which the tests are
run. The default setting is 10, the slowest setting. If you choose 1, the
fastest setting, the tests run very rapidly. However, you can stop the screen by
pressing PREV PAGE, and restart it by pressing NEXT PAGE. The speed you choose
becomes the new default setting until it is changed.
Provide labels?
This question allows you to suppress verbal descriptions of each test from the
screen. Since the Color Monitor tests are not self-checking, labels are provided
to help you verify what you see. The default on this question is Y, so you must
type in N to suppress the labels. Once suppressed, this becomes the new default
setting until it is changed.
The following tests are run when the Color Monitor is selected.
6-2