Download Checklist A Procedures

Section 3 • Scheduled Maintenance Procedures
February 2012
CHECKLIST A PROCEDURES
A-14
Perform Engine Maintenance GM and Ford Models
A-15
Perform Engine Maintenance Perkins Models
Note: Engine specifications require that this
procedure be performed every 200 hours.
Note: Engine specifications require that this
procedure be performed every 200 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
GM 3.0L Operator Handbook
(GM part number 36100007) OR the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302) OR the
Ford DSG-423 EFI Operator Handbook
(EDI part number 1060020).
Required maintenance procedures and additional
engine information are available in the
Perkins 400 Series Operation Manual
(Perkins part number TPD 1443S).
GM 3.0L Operator Handbook
Genie part number
To access the engine:
Ford LRG 425 EFI Operator Handbook
Genie part number
Ford DSG 423 EFI Operator Handbook
Genie part number
Perkins 400 Series Operation Manual
Genie part number
94890
101095
84792
119488
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
3 - 16
S-60 • S-65 • S-60 HC
Part No. 77828