Download (MSP) Configuration and Administration Guide

SMC0109 - SMC0111
SMC0109
The SMC subsystem is running in key n; results are unpredictable;
reply ‘Y’ to continue or ‘N’ to terminate
Message Level: 0
Explanation: During initialization SMC detected that it is running in key n,
not 1 through 7.
System Action: The SMC waits until a reply is received.
User Response: A reply of N stops SMC. A reply of Y causes SMC to continue
initialization, though results are unpredictable. Possible problems are S0C1 and S0C4
ABENDs. To prevent this message, update the Program Properties Table (PPT) with “PPT
PGMNAME(SMCBINT),SYST,KEY(n)”, where n is between 1 and 7, inclusive.
SMC0110
Allow swap of VVVVVV from XXXX1 to XXXX2; Reply ‘Y’, ‘N’ or
DEVICE
Message Level: 0
Explanation: The SMC has intercepted DDR swap processing. The SMC is awaiting
operator approval to allow the swap.
System Action: The SMC continues processing; however, the swap cannot complete until
an operator reply is entered.
User Response: To allow the swap to proceed using the selected device XXXX2, reply Y.
To select a different swap to device, reply with its device address. The SMC does not
validate a new device address. To cancel the swap, reply N. If an I/O error on device
XXXX1 caused the swap, a reply of N causes the job to fail.
SMC0111
USER defined message ID: MMMMMMMM
Message Level: 0
Explanation: The SMC has listed the messages that were added using the USERMsg
command.
System Action: Both SMC default and USERMsg added messages are sent to user exit 01
for each library subsystem. SMC processes USERMsg added messages according to the
response from user exit 01.
User Response: None.
Chapter 9. SMC Messages 169
312614001 Rev. B