Download spec A-G

Assembly Procedure
Exhaust gas can cause severe perTo prevent
exhaust leaks, install all gaskets, clamps, straps, and
hardware as specified.
(BWAR"G( sonal injury or death.
1. Installthe exhaust manifold using new gaskets and
tighten the four manifold screws to the specified
torque.
5. Installthe two 114-20 screwsand lock washers that
secure the muffler support bracket to the set and
tighten muffler clamp.
To prevent excessive vibration
transfer to the vehicle, mount
muffler and tailpipehanger bracketsdirectly above
the component being supported and NOT at an
angle.
1-
2. Replace the noise shield and scroll (refer to the
Cooling System section).
6. If replacingthe originaltailpipe, refer to the Tailpipe
Recommendations section to select and locate the
tailpipe. Attach the tailpipe to the outlet end of the
muffler. Secure it using a 1-3/8 inch U-bolt type
automotive muffler clamp.
If no other service is required, install the generator set in the
vehicle before completing the remaining steps.
7. Support the tailpipe using a shock-mounted support hanger with clamp.
3. Place a U-bolt type automotive muffler clamp
(marked 1-114)in position on the exhaust manifold
(near elbow) prior to installing muffler.
4. Place muffler in position on set making certain that
the muffler inlet pipe overlaps exhaust manifold a
minimum of 1-112 inches (38 mm).
Redistribution or publication of this document,
by any means, is strictly prohibited.