Download Section 8 Technician Level Maintenance

Section 8 - Maintenance
Remove governor and throttle Disconnect the governor from
body from intake runner.
the throttle body.
Remove the two screws that
hold on the throttle plate.
Remove the end cap.
Remove the retaining screw.
Note the orientation of the
spring.
Use a drift and mallet
to remove the shaft and
Carefully note the order in
which the components are
The outside bearing is held
in place with a pressed-
Page 8-7
770-00091 Section 8_Maintenance (PP20) Rev B
770-00083 Power Pallet Technician's Handbook (PP20/v1.09) Rev B