Download SPICER AXLE

SERVICE PROCEDURES
NOTE
It is recommended that whenever the ring
gear screws are removed, they are replaced
with new ones.
. ;.� �L
1
?
-··
Figure 22
1o21-24
Figure 24
To remove side gears and pinion mate gears,
rotate the side gears. This will allow the pinion
mate gears to turn to the opening of the case.
Remove pinion mate gears and also the spherical
washers behind the gears. Lift out gears and
thrust washers. Inspect all parts, including the
machined surfaces of the case itself. Where
necessary replace all worn parts. If excessive wear
is visible on all parts, it is suggested that the
complete differential assembly be replaced. If any
one of the gears are to be replaced, they are to be
replaced as a set.
1021-22
Replace case in vise and drive out lock pin which
secures the pinion rnate shaft. Use a small drift as
shown.
Figure 25
1021-2s
Turn nose of carrier in a vertical position to
remove pinion nut. Hold end yoke with tool as
shown, and remove pinion nut and washer.
Figure 2 3
1o21-23
Remove pinion mate shaft with drift as shown.
Tool-C-3281 Holding Wrench.
11