Download Installation Instructions
Transcript
Accessory INSTALLATION INSTRUCTIONS Application MII 14360 ACCESSORY SOCKET GL1800B P/N 08E70-MJG-670 Issue Date December 2012 PARTS LIST INSTALLATION NOTE: • Disconnect the negative (-) cable from the battery before installing this accessory. • After turning the ignition switch OFF, wait more than 10 seconds and then remove the negative (-) battery cable. • The memories of the tripmeter and clock will be erased when you disconnect the battery. Reset the clock after reconnecting the battery. • Reinstall the removed parts on the motorcycle and make sure that the wires and harnesses are not pinched. • Trim the excess ends off the wire ties after attaching them to the wire harnesses. Do not allow the cut part of the wire tie to interfere with another harness or brake hose. (2) (1) (3) No. Publication No. Description Qty (1) Installation Instruction URL 1 (2) Accessory socket 1 (3) Wire tie 1 1. Open the left saddlebag lid as shown. SUPPLIES REQUIRED Electric drill Holesaw (30 mm) Side cutters Marker Ruler File TORQUE CHART Refer to the Service Manual for the torque values of the removed parts. LEFT SADDLEBAG LID 2. Remove the left side cover, and disconnect the negative (-) cable from the battery. LEFT SIDE COVER © 2012 Honda Motor Co., Ltd. - All Rights Reserved. 1 of 3 87946-MJG-6701 3. Remove the left cowl trim mould as shown. 5. LEFT COWL TRIM MOULD Drill at the marked point of the left front pocket as shown. • Remove any burrs from the edge of the hole. LEFT FRONT POCKET 4. Remove the left front pocket as shown. CLIP MARK ELECTRIC DRILL (30 mm HOLESAW) Using a file, remove the from the left front pocket. FILE 5 mm LEFT FRONT POCKET 3 mm 2 of 3 part 6. Route the accessory socket harness from the inside of the pocket and secure it with the nut as shown. 8. ACCESSORY SOCKET Secure the accessory socket harness with the wire tie as shown. WIRE TIE Secure the accessory socket harness to the motorcycle’s harness. LEFT FRONT POCKET ACCESSORY SOCKET HARNESS NUT Remove from the accessory socket before passing through the hole. FUSE ACCESSORY SOCKET HARNESS 9. 7. Connect the accessory socket harness as shown. LEFT FRONT POCKET ACCESSORY SOCKET HARNESS 3-PIN CONNECTOR (Red) After connecting, store the connector in the harness boot. HARNESS BOOT 3 of 3 Install the motorcycle’s parts in reverse order of the removal. • Confirm that any wire harness is not caught or too tight.