Download Comparison & Contrast

Transcript
Access to Apprenticeship
Workplace Support Services Branch, Ontario Ministry of Training, Colleges and Universities
Revised
2011
Answer page
PART I
Table 1, Fillers and Putties
1. Which is not common to both lightweight and heavyweight fillers?
b) talc particles; used on dents, dings; non-shrinking
A careful comparison of the descriptions of both lightweight and heavyweight fillers is
needed.
2. Which of the following describes premium and heavyweight fillers?
a) non-sagging; used on metal panels
3. Which fillers have best spreading characteristics?
b) lightweight and premium
4. Which filler would you choose to avoid pinholing on metal panels?
c) premium
PART III Passage 4, Galvanic Corrosion and Table 2
1. According to Passage 5 and Table 4, aluminum is more chemically active than nickel.
T Find each metal on Table 4 and compare its position to the other to determine which is
least and most active.
2. If iron and nickel are in contact with each other, the nickel will corrode.
F “Whichever of the two metals is more chemically active will corrode.” The more active
metal in the table is iron. The nickel, therefore, would not corrode.
3. Galvanic corrosion may cause problems even when dissimilar metals are in the least
chemically active area.
T If dissimilar metals are in contact, problems can occur. This is why you are directed to
use the same materials for fittings.
PART III Passage 5, Hose Size and Air Pressure Drop
1. Low pressure and short lengths of hose may cause a significant drop in air pressure.
F Although there is a relationship between the two, Paragraph 4 states that this combination
would not cause a significant drop.
Communication Skills for The Auto Body Repair Trades
Comparison of Information
Page 16