1
Download Operator`s Guide - Oracle Documentation
Transcript
MODify RESET resets internal flags for any host that may be failing as a hardware configuration is being performed. When the failing host comes back up, the new hardware configuration is automatically recognized and implemented. A reset is intended only to reset a failing host and does not initiate the actual dynamic hardware reconfiguration operation. The MODify CONFIG command, without the RESET parameter, must be run separately to invoke dynamic hardware reconfiguration. UPDate initiates an NCO configuration change to update the ACS configuration specified in the ACS(acs-id) parameter. ACS(acs-id) indicates a hexadecimal value from 00 to FF that identifies the ACS. This is not a system-wide change and does not propagate to other hosts connected to the CDS. If a system-wide update is needed, enter the MODify CONFIG command minus any additional parameters. 178 MVS/HSC 6.1 Operator’s Guide Rev. E, 5/31/09 - 312597201
