Download StudyGuide suspension and Steering

Transcript
©2004 Melior, Inc.
Steering and Suspension Systems Study Guide
_____________________________________________________________________________________________
•
Many light truck and four-wheel-drive applications use another part shown above, a steering damper. A steering damper
is a steering stabilizer that looks and functions like a shock absorber. The purpose of a steering damper is to absorb
shimmy (rapid back-and-forth oscillation of the front wheels) or wheel kick. One end of the damper is mounted to the
steering linkage, and the other mounts to the vehicle frame. As the wheels turn, a hydraulic piston is forced through an
oil-filled cylinder. Small, calibrated holes allow the oil to flow in and out of the piston chambers at a controlled rate,
preventing the steering linkage from moving back and forth too rapidly. Steering dampers may be original equipment or
add-ons, and are most common on off-road or severe duty applications.
Steering Damper
Haltenberger Linkage
•
Used on twin axle four-wheel-drive suspensions and twin I beam suspensions like the one shown below.
•
No idler arm is used; instead, a long right connecting rod is attached to the pitman arm, and the left inner tie rod end is
attached to the connecting rod.
Haltenberger Linkage
Power Steering Systems
•
Most steering systems used today are power assisted, though there are still some manual units produced. For easier
steering on manual units, the gear ratio is usually about 24 to 1, so you would have to turn the steering wheel 12 times to
turn the sector shaft through one half a rotation. Power assisted units normally have a ratio of about 15 to 1, providing a
quicker turning response. Turning the steering wheel only 7 times will move the sector shaft through nearly a half a
rotation.
•
Nearly all power steering systems use a belt-driven pump to provide hydraulic steering assistance, although a few electric
power assisted rack-and-pinion units are beginning to appear. These units use an electric motor to assist in moving the
rack.
•
Vehicles with hydraulic power steering must use an approved power steering fluid. Automatic transmission fluid has been
widely used, but may not be approved for later models.
Power Steering Pump
•
Four main types of power steering pumps have been used. They are the roller, vane, slipper, and gear types. The
pump must provide sufficient pressure for steering assist at all engine speeds to meet the various steering demands.
•
A fluid reservoir is often mounted on the pump housing, or it may be a separate component.
•
The need for assist is greatest during periods of low-speed maneuvering, which may occur at idle or low engine speeds,
and less when cruising at high speed.
•
When the pump is turning fast and steering demands are low, most of the fluid is diverted back to the inlet side of the
pump through a pressure relief valve. The two-stage pressure relief and control valve provides the correct amount of
steering assist at different rpms, and opens a bypass port to the pump intake when pressure gets too high.
•
Some power steering pumps are capable of producing up to 1,500 psi.
•
A power steering pump can require a significant amount of horsepower. Some vehicles’ control module will sense the
increased engine load caused by power steering demands at idle and increase the idle to prevent stalling or stumbling.
The control module may also turn off the A/C compressor or the alternator at such times.
_____________________________________________________________________________________________
9