Download SPARC Enterprise Equipment Rack Mounting Guide

3.7.2
No.
Parts Name
Required Number
2
Middle-sized bracket
Not used
3
Small-sized bracket
1
4
M5 screw
2
5
M5 cage nut
2
Safety Against Overturning
1. Take appropriate measures to prevent the rack from toppling over.
For details, see Section 3.4, “Equipment Rack Mounting Requirements” on page 3-12.
As an example, the procedure for attaching the quake-resistant options kit to the
rack is shown below.
FIGURE 3-67
Pulling Out the Pull-out Quake-Resistant Options Kit
Stopper bracket
Slide chassis
Level
foot
End mark
Caution – Be sure to pull the slide chassis all the way out to the point indicated by
the end mark. If the slide chassis is not pulled all the way out to the end mark point,
the equipment rack may topple over when drawing a server out from a rack.
3-80
SPARC Enterprise Equipment Rack Mounting Guide • September 2011