1
Download RAV Training - HVACpartners
Transcript
Service Removing the control board Remove the grille Remove the cover of the control box Remove the following connectors from the board by unlocking the clip on the connector: CN510: Louver motor – 20 wires CN34 : Float switch – 3 wires CN504: Drain pump – 2 wires CN101: TC sensor – 2 wires CN102: TCJ sensor – 2 wires CN104: Room temperature sensor – 2 wires CN333: Fan motor power supply – 5 wires CN334: Fan motor position detection – 3 wires Unlock the 6 board clips (edge spacer) and remove the board Installing the control board Reverse the above steps Back to main menu Back to Service
